Event Details

  • In the actual production process of building sand, sand making machine production capacity will be affected by many factors, in the experience of many users and manufacturers of scientific analysis, these factors can be divided into five categories, and puts forward the solutions to the influence of the five aspects of the results following up for your reference:

    The composition of the material, the more fine powder contained in the material before making sand, the more influence the sand making, because these fine powders are easy to adhere to the influence of transportation. Therefore, the material with more fine powder should be screened in advance. The fine powder is selected from the material as far as possible so as not to affect the normal work of the sand making equipment.

    The hardness of the material. The harder the material is to break up, and the more serious it is to the wear of the equipment. The speed of sand making is slow, and of course the sand making capacity is small. This requires us to be moderate in the selection of materials.

    After making sand, the fineness and fineness of the material are high, that is, the thinner the material from the sand is required, the smaller the sand making ability is. In this respect, it is necessary to see the specific requirements of the mineral processing plant. If there is no special requirement, the fineness of the material is generally set to medium and fine.

    The viscosity of the material. That is, the greater the viscosity of the material, the more easy it is to adhere. The material with large viscosity will stick to the inner wall of the sand making chamber in the crusher. If it can not be cleaned in time, it will seriously affect the efficiency of the sand making machine and seriously affect the normal operation of the sand making machine. Therefore, when choosing the material, be sure to pay attention to the viscosity of the material is not too large.

    When the moisture content of the material is large, the material is easy to stick in the sand making machine, and it is also easy to block up in the transportation process, resulting in the reduction of sand making capacity. To solve these problems, first of all, material temperature should be strictly controlled when selecting materials. If the temperature of selected materials is too large, sunlight or air drying can be used to reduce the percentage of moisture in the material.
  • 1/2/18 at 1:00 AM -
    1/31/18 at 1:00 AM
  • RSVPs
    • 1 attending
    • 0 maybe attending
    • 0 not attending
    • 0 awaiting reply

How to improve the working ability of the sand making machine?

Nothing has been posted here yet - be the first!